General Pics
 Rollbar Install

Voodoo Pearl Magnum

Here are several full-car pics of my Miata. So far my mods include: Boss Frog rollbar, clear front corner lights and a Voodoo Magnum Pearlcoat.
These are low res versions, click on each pic to see a 800x600 high quality version.
Front shot
Head on, Topless
Head on, top up
Behind, No top
Behind, top up
Behind, higher shot
Side, top down
Front Angle
Rear angle
Rear angle, low
Rollbar plus seats, The seats are Touching the bar, but I have put the soft side of velcro on the bar and seats to prevent rubbing.
Drivers seat, in moderate recline, and with the seat moved almost all the way back to angle the seat a bit. this is pre-velcro, just after I finished the install. Roomates former ride, G35 Coupe. He traded up to a RX-8.
A rear shot, just giving a refrence of how the seats interact with the bar. Thats my roommate's 240z in the background.
Yet another shot that shows the seat/bar interaction. I have so many of these because I couldn't find them when i was researching the bar.

A side shot of the seats at a higher angle
A low close shot of how the driver's side seat interacts with the bar. I like to have more recline in my seat, so my head sits a bit lower.
A shot of how the passenger seat interacts with the bar. I have less recline in the pass seat, and scoot it forward a bit.
A shot of how the bar interacts with the top and the seatbelt tower, driver's side
A shot of the finished passengers side seatbelt tower
A shot of how the rear support leg interacts with the top, passenger side.
Another top/leg shot. Still passenger.
A shot of how the yoke sits against the back wall. It fits pretty snug, but does not in any way interfere with the operation of the console, the keyhole or the seats.
A shot of where the side leg of the bar goes. Right after I re-cut some of the trim. Also, with the rollbar, those little slots where you put the tabs of the seatbelt really come in handy now.